P16, P32, P64

Panneaux de commande hybrides de nouvelle génération adaptés aux objets nécessitant jusqu’à 64 détecteurs. Les panneaux de la série P comparés au PAS sont complétés par un circuit de contrôle du détecteur de fumée à 2 fils et un module de réception pour les signaux des capteurs sans fil. En outre, la série P dispose d’une option pour connecter en toute sécurité ces communicateurs plug-in interchangeables: GSVu, PSTP et VIDNET. Trois différents modèles de panneaux de la série P sont disponibles – P16, P32, P64, et conviennent par conséquent aux détecteurs câblés ou sans fil 16, 32, 64.

Next-generation hybrid control panels suitable for objects requiring up to 64 detectors. The P-series panels compared to the PAS are completed with a 2-wire smoke detector control circuit and a receiving module for signals from the wireless sensors. In addition, the P series has an option to securely connect these interchangeable plug-in communicators: GSVu, PSTP and VIDNET. Three different models of P-series panels are available - P16, P32, P64, and are therefore suitable for wired or wireless detectors 16, 32, 64.

Features	P16	P32	P64
Concept of alarm system	Hybrid modular system	Hybrid modular system	Hybrid modular system
Wired areas on board	7/14 (double)	7/14 (double)	7/14 (double)
2-wire smoke detector input	1	1	1
On-board wireless zones	16	32	64
Maximum PGM in the system	16	32	64
Embedded PGM	3	3	3
Maximum PGM in system	16	16	16
User + installation codes	31 + 1	31 + 1	63 + 1
Default user code	X1, X2, X3, X4 (when X4 = X4 + 1)
Defaulting user code	Yes	Yes	Yes
Key switch zone	Yes	Yes	Yes
Partitions	4	4	4
Sharing “Shared” (common area)	Yes	Yes	Yes
System timers	16	16	16
Maximum number of keyboards / modules in the system	15	15	15
Event log buffer	512	512	512
PSTN communicator	Connect to	Connect to	Connect to
Integrated interface for backup communicator	TTL serial	TTL serial	TTL serial
Data bus protocol	KRBUS	KRBUS	KRBUS
Total phone numbers: CMS reports + personal numbering	9	9	9
Maximum number of telephone numbers for personal dialing	Up to 5	Up to 5	Up to 5
Maximum number of phone numbers for CMS reports	Up to 4	Up to 4	Up to 4
Reporting protocol	Contact ID	Contact ID	Contact ID
Voice guide for system control over PSTN	Yes	Yes	Yes
Voice guide for programming the system on PSTN	Yes	Yes	Yes
Type of detector “Roller”	Yes	Yes	Yes
Type of detector “Vibration”	Yes	Yes	Yes
Speed of the “Vibration” zone (sensitivity)	0.01 - 0.25 sec.	0.01 - 0.25 sec.	0.01 - 0.25 sec.
Normal zone speed (sensitivity)	0.1 - 2.5 sec.	0.1 - 2.5 sec.	0.1 - 2.5 sec.
Zone loop type (detector)	NC, NO, NF / EOL, NO / EOL, NC / DEOL, NO / DEOL, vibration, roller
Arming mode	Away, Max Away, Night, Rest.
Zone definition	Entry / exit, forced entry / exit, interior, interior night armed, tracker, tracker night armed, perimeter, snapshot, PGM control; 24h: burglary, silent panic, audible panic, sabotage, fire, smoke, fire button, medical button, fire watch, low water level, RF jam, gas detected, water leak, high temperature, low temperature
Zone attributes	Activate bypass, no alarm, arm when door is closed, route of entry, exit, fire verification, alarm limitation, signaling limitation, pre-alarm, night armed < / td>
PGM definition	Fire alarm, fire / burglary alarm, burglar alarm, tamper alarm, technical alarm, selected alarms, chime, zone violation, bypass status, selected fault, exit / entry warning, status output / arm, full arm state, power supply, fire power supply, timer, mono / bi switch
PGM attributes	Reversal, heartbeat, lock, pre-alarm, arming notification, arming failure notification, disarming notification, cleared alarm notification, armed in specific mode
Nominal power supply voltage (AC)	~ 20 V	~ 20 V	~ 20 V
Minimum AC voltage (Note: the input voltage of ~ 16 V allows the control panel to generate an output current of 0.7 A maximum)	~ 16 V	~ 16 V	~ 16 V
Maximum AC voltage (Note: voltage above ~ 22V may damage the control panel)	~ 22 V	~ 22 V	~ 22 V
Maximum long term control panel output current (I _{+ AUX} + I _{+ BELL} + I _{+ PGM} + load battery):	≤1.5 A	≤2.0 A	≤2.0 A
Maximum current of slow blow fuse used in primary alternating current	250 mA	250 mA	250 mA
Maximum AC power consumption	150 mA	150 mA	150 mA
Minimum voltage on the + AUX, + BELL, + PGM outputs	12 V	12 V	12 V
Maximum voltage on the + AUX, + BELL, + PGM outputs	13.9 V	13.9 V	13.9 V
Maximum current on + AUX	+1 A	+1 A	+1 A
Maximum current on + BELL	+2 A	+2 A	+2 A
Maximum current in -PGM	-0.3 A	-0.3 A	-0.3 A
Maximum current on + PGM	+0.5 A	+0.9 A	+0.9 A
Short circuit, overload protection of + BELL, + PGM, + AUX	Electronics	Electronics	Electronics
Battery charge, + BELL, + AUX current measurement	Yes	Yes	Yes
Failed to disconnect backup battery (waste)	Yes	Yes	Yes
Maximum battery charge current	0.35 A	0.35 A	0.35 A
Maximum current of the fast blow fuse used in the battery circuit	3.15 A	3.15 A	3.15 A
The control panel disconnects the battery when its voltage is lower than	9.5 V	9.5 V	9.5 V
Recommended backup battery	12 V, 7 Ah / 20 Hr	12 V, 7 Ah / 20 Hr	12 V, 7 Ah / 20 Hr
Operational compliance	+ EN50131, Grade2	+ EN50131, Grade2	+ EN50131, Grade2
Overall dimensions W x H in mm	145 x 77	145 x 77	145 x 77
Respect for the environment	ROHS	ROHS	ROHS
Operating temperature	- 10 ^o C to +50 ^o C
Production status	In production	In production	In production
Latest firmware version	v0.03	v0.03	v0.03
Firmware upgrade in the field (via USB)	Yes	Yes	Yes